Unistrut – P1000H3 – 1-5/8″ x 1-5/8″, 12 Gauge; Round Holes on all three sides

Features:

• Product dimensions are 1 5/8″ wide x 1 5/8″ tall x 12 ga. thick; with round holes on three side.
• Holes for 1/2″ rod and fasteners
• The hole diameters and spacing match Unistrut’s General Fittings so that nearly all of our Fittings can be attached through these holes, allowing attachment to all sides of the channel.
• Telescopes with P9200 Telestrut
• Our P1000H3 is available in the following finishes: Pre-Galvanized (PG), Hot-Dip Galvanized (HG), Plain (PL) and Green (GR).
• Made in the USA

Standard Lengths:

• 10 feet:  10′ or 10’ ¹/₈” (3.05m) ± ¹/₈” (3 mm)
• 20 feet:  20′ or 20’ ³/₈” (6.11m) ± ¹/₈” (3 mm)

Special Lengths:

• Available with a tolerance of ±¹/₈” (3 mm)

Curved Channel:

• Many Unistrut channel sections can be supplied with a curve.

Load Data:

• All beam and column load data pertains to carbon steel and stainless-steel channels.
• Load tables apply only to UNISTRUT brand channel. Look for “UNISTRUT” on the product.
• Load tables and charts are constructed to be in accordance with the SPECIFICATION FOR THE DESIGN OF COLD-FORMED STEEL STRUCTURAL MEMBERS 2007 EDITION published by the AMERICAN IRON AND STEEL INSTITUTE USING ASD METHOD.
• Loads are based on 33 ksi steel cold formed to 42 ksi.
• Safety Factor to Yield Strength is 1.67 for Beam Loads and 1.80 for Column Loads.
• Beam loads are based on a simple beam and are given as a total uniform load (W) in pounds. For proper calculation procedures, refer to our Beam Load Calculation Guide under Resources.

Materials & Finishes

Materials & Finishes – Standard:

• Pregalvanized (PG):  Conforms to ASTM A653 SS GR 33, G90.
• Unistrut Defender (DF):  Conforms to ASTM A1046 SS GR 33
• Hot Dip Galvanized (HG):  Steel conforms to ASTM A1011 SS GR 33, Finish conforms to ASTM A123
• Perma-Green (GR):  Steel conforms to ASTM A1011 SS GR 33, E-Coat finish
• Perma-Gold (ZD):  Steel conforms to ASTM A1011 SS GR 33, Finish conforms to ASTM B633, Type II SC3
• Plain (PL):  Conforms to ASTM A1011 SS GR 33

Materials & Finishes – Special Metals:

• Stainless Steel, Type 304 (SS):  ASTM A240, Type 304 *
• Stainless Steel, Type 316 (ST):  ASTM A240, Type 316 *
• Aluminum (EA):  ASTM B221, Type 6063-T6 (Extruded) *

* These materials have different physical properties and performance characteristics.